2024 Yamaha Tenere 700 Dialdim and Trigger Wizard wiring
2024 Yamaha Tenere 700 Dialdim and Trigger Wizard wiring
Here's the breakdown of the trigger wizard
The black wire on the Trigger Wizard will be tapped to the high beam wire (yellow wire - pictured below).
The white wire on the Trigger Wizard, on the left, can be tapped to the blue wire in the turn signal connector (pictured below). This wire runs the DRL within the turn signal pod.
The White and blue wires on the right side of the diagram above, will be tapped to the white (ignition) and blue (high beam) wires on the DialDim.
This leaves just the turn signal wires and horn wires to be connected.
The turn signal wire (orange wire - right turn) on the DialDim will be tapped to the white wire in the bike's turn signal connector. Match this on the other side of the bike for the left turn signal.
For the headlight, the high beam wire is the yellow wire outlined below.
The horn positive wire is the pink wire on the bike. The green horn trigger wire on the DialDim, will be tapped there.
Related Articles
Controller Comparison: DialDim vs. Cansmart
Controller Comparison: DialDim vs CANsmart DialDim Controller Vehicle Specific Kit CANsmart Controller Vehicle Specific Kit Some Plug-&-Play Installation kits available/Primarily Universal Plug-&-Play Installation On/Off & Dim (2 sets of driving ...DialDim Controller Brightness Controls – How They Work
DialDim Controller Brightness Controls – How They Work Symptom • Customer is unsure how brightness levels change • Lights appear too dim or too bright • Brightness changes automatically when riding Observed behaviour • Lights dim or brighten ...How the D7Pro differs from the D7 regular.
How the D7Pro differs from the D7 standard. The D7 Pro differs from the regular D7 in a pretty severe way. You should really consider a pair of D7 Pro Pods as two pairs of light pods in one. The wiring pigtail of the D7 Pro Pods splits into two, ...3 Circuit Programming guide for D7 Pro pods on a Cansmart/Ezcan
D7 Pro Pods with CANsmart / ezCAN - How-To Guide Overview This guide explains how to wire and program D7 Pro Pods using three circuits on a CANsmart/ezCAN system. The fourth circuit is reserved for a B6 Brake Light or B6 Dual Brake Light. Quick ...