How to Perform a Hard Reset on a Cansmart

How to Perform a Hard Reset on a Cansmart

CANsmart Hard Reset Instructions

1.      Turn vehicle ignition off.

2.      Remove fuse from CANsmart battery wire.

3.      Disconnect CANsmart from motorcycle's CANbus connector.

4.      Disconnect CANsmart from USB/computer. Ensure LED indicator is completely off and remains off.

5.      Wait at least 5 minutes.

6.      During this time, uninstall the software from your computer.

7.      Redownload and reinstall the software.

8.      Run the software and wait for the 'connect device to continue' dialog to appear.

9.      Once prompted, plug ONLY the USB cable into CANsmart using the supplied cable. Leave all other connections disconnected.

10.  Reconnect CANsmart to the bike by reconnecting the CANbus connector, then reconnect the fuse.



    • Related Articles

    • Cansmart Troubleshooting Checklist

      Troubleshooting Checklist – CANsmart Not Powering On Issue: CANsmart is not powering on No accessories working No LED indicator light with ignition Basic Checks Confirm the fuse is installed Inspect the fuse: Check if the interior metal bridge is ...

    • Controller Comparison: DialDim vs. Cansmart

      Controller Comparison: DialDim vs CANsmart DialDim Controller Vehicle Specific Kit CANsmart Controller Vehicle Specific Kit Some Plug-&-Play Installation kits available/Primarily Universal Plug-&-Play Installation On/Off & Dim (2 sets of driving ...

    • 3 Circuit Programming guide for D7 Pro pods on a Cansmart/Ezcan

      D7 Pro Pods with CANsmart / ezCAN - How-To Guide Overview This guide explains how to wire and program D7 Pro Pods using three circuits on a CANsmart/ezCAN system. The fourth circuit is reserved for a B6 Brake Light or B6 Dual Brake Light. Quick ...

    • How the D7Pro differs from the D7 regular.

      How the D7Pro differs from the D7 standard. The D7 Pro differs from the regular D7 in a pretty severe way. You should really consider a pair of D7 Pro Pods as two pairs of light pods in one. The wiring pigtail of the D7 Pro Pods splits into two, ...